Screen Door Handle With Lock
Storm Door Handle Set Security Deadbolt Screen Latch Push Lock in sizing 1000 X 1000Screen Door Handle With Lock – A screen door is a great way to not just allow some fresh air and sunshine into your house, but also to keep insects and other pests outside at the same moment. By using a screen door, you have the ability to maintain your house enclosed, while still allowing a breeze, possibly when the weather is warm or anytime you only want to allow a bit of fresh air in. Although you can purchase screen doors for your house, they are in fact fairly simple to make, requiring just a few tools and supplies, using simple building methods. Screen doors can be either very simple in layout, or could be more elaborate, based on your wants and building abilities.
Supplies you’ll need, You will require some thin wood stock to use for the screen door construction, a hardware frame for the doorway itself, and screen meshing, along with a 1/4 inch by 3/4 inch screen molding. Some basic tools such as a tape measure, hamper, knife, chisel, staple gun and clamps will be necessary.
Choose a well-dried timber to avoid future timber shrinkage, discoloration or warping. Measure the dimensions of the doorway you need to build, and cut the vertical and horizontal pieces to fit. While constructing the doorway, it can help to clamp the door pieces to a table. To produce the corner joins, in addition to when adding the centre horizontal support piece, you’ll need to take off half of the depth of one piece of timber at the place where they will match a saw, so the general finished thickness of the joint will be equal to that of one piece of wood. Use a polyurethane glue and a brush to attach the timber support pieces together, and then clamp and allow to dry thoroughly. Once the glue joints are completely dry, you can sand the doorway, and apply a stain and clear finish, or paint the door if desired.
Adding the Screen to the Door, Laying the doorway flat on the work table, measure the general opening and cut a piece of screen material into the appropriate dimensions, leaving several inches around the edges to make setup easier, which will be trimmed later. Lay the screen over the top of the door frame, and staple it to the peak of the frame, pulling it closely towards the base of the doorway. Make sure that you pull the screen tightly from the flat directions too, keeping in mind that screen tends to elongate over time. The screen can be stapled directly to the doorway, as the principles will be covered by molding which will be placed around the edge of the screen. After the screen was stapled securely into place, trim the screen and cover the edges with the screen molding.
Finishing the Job, when the doorway itself was assembled, it is possible to set up the door frame itself, and attach the new screen door into the frame. Attach a door handle and secure the door into the frame using spring hinges so the door will shut automatically.
