Doggy Door For Sliding Screen Door

Pet Door For Sliding Glass And Screen Doors Maximum Security with regard to sizing 1280 X 720

Doggy Door For Sliding Screen Door – A screen door is a superb way to not just let some fresh air and sun to your house, but also to keep insects and other pests outside at precisely the same moment. By employing a screen door, you also have the ability to keep your house enclosed, while allowing a breeze, either when the weather is warm or anytime you only want to let just a little bit of fresh air in. Although you can buy screen doors for your house, they are actually fairly straightforward to make, requiring just a few tools and supplies, using simple construction methods. Screen doors can be either very simple in design, or could be more elaborate, depending upon your wants and construction abilities.

Supplies you’ll need, You will require some thin wood inventory to use for your screen door structure, a hardware framework for the doorway itself, and screen meshing, along with a 1/4 inch from 3/4 inch screen molding. You will also require paint brushes, glue brushes, varnish and 1 inch nails.

Pick a well-dried wood to avoid future wood shrinkage, discoloration or warping. Measure the dimensions of the doorway you want to build, and cut the horizontal and vertical pieces to match. While building the doorway, it can help to clamp the door bits to a table. To make the corner combines, in addition to when adding the centre horizontal support piece, you’ll want to take off half of the depth of a single piece of wood at the place where they will intersect with a saw, so the overall finished thickness of this joint will be equivalent to that of one piece of wood. Use a polyurethane glue and a brush to attach the wood support bits together, then clamp and allow to dry completely.

Adding the Screen to the Door, Laying the doorway flat on the job table, measure the overall opening and cut a piece of screen material to the proper dimensions, leaving several inches around the edges to make installation simpler, which is trimmed later. Lay the screen over the surface of the door frame, and staple it to the top of the framework, pulling it closely towards the base of the doorway. Be sure that you pull the screen tightly in the flat directions too, keeping in mind that screen will stretch over time. The screen can be stapled directly to the doorway, as the principles will be covered by molding that will be placed around the border of this screen. After the screen was stapled firmly into position, trim the screen and cover the edges with the screen molding.

Finishing the Job, Once the doorway itself was assembled, you can install the door frame itself, and also attach the new screen door to the framework. Attach a door handle and secure the door to the framework using spring hinges so the door will shut mechanically.