Screen Pet Doors

Hale Pet Doors Pet Doors For Screens Petdoors intended for measurements 1100 X 1100

Screen Pet Doors – A screen door is a great way to not only allow some fresh air and sun to your house, but also to keep insects and other pests out in the exact same moment. By employing a screen door, you also have the capacity to maintain your house enclosed, while still allowing a breeze, possibly when the weather is warm or anytime you just need to allow a bit of fresh air in. Even though you can purchase screen doors for your house, they are actually fairly simple to make, requiring only a few tools and supplies, using simple construction methods. Screen doors can be either very simple in layout, or could be elaborate, based on your wants and construction abilities.

Supplies You Will Need, You will require some thin wood inventory to use for your screen door structure, a hardware frame for the doorway itself, and screen meshing, along with a 1/4 inch by 3/4 inch screen molding. You’ll also require paint brushes, glue brushes, varnish and 1 inch nails.

Choose a well-dried wood to avoid future wood shrinkage, warping or swelling. Measure the dimensions of the doorway you want to construct, and cut on the vertical and horizontal pieces to fit. While building the doorway, it can help clamp the door pieces to a table. To produce the corner combines, in addition to when adding the center horizontal support piece, you will want to take off half the thickness of one piece of wood at the place where they will match a saw, so the general finished thickness of this joint will be equal to that of a single piece of wood. Utilize a polyurethane glue and a brush to attach the wood service pieces together, and then clamp and allow to dry thoroughly.

Adding the Screen to the Door, Laying the doorway flat on the job table, measure the general opening and cut a piece of screen material to the appropriate dimensions, leaving a few inches around the edges to make setup easier, which will be trimmed later. Lay the screen over the top of the door frame, and staple it to the top of the frame, pulling it tightly towards the bottom of the doorway. Be sure that you pull on the screen tightly from the horizontal directions as well, keeping in mind that screen will stretch over time. The screen can be soldered right to the doorway, as the staples will be covered by molding which will be placed around the border of this screen. After the screen was stapled firmly into place, trim the screen and cover the edges with the screen molding.

Finishing the Job, when the doorway itself was assembled, you can set up the door frame itself, and then attach the new screen door to the frame. Attach a door handle and secure the door to the frame with spring hinges so the door will shut mechanically.