Magnetic Screen Door For French Doors
Magnetic Screen Door Magic Mesh Screen Doors Retractable Door in dimensions 1280 X 720Magnetic Screen Door For French Doors – A screen door is a great way to not only allow some fresh air and sun to your home, but also to keep insects and other pests out in precisely the same time. By employing a screen door, you also have the ability to maintain your home enclosed, while allowing a breeze, either when the weather is hot or anytime you just want to allow a little bit of atmosphere in. Although you can purchase display doors for your home, they are actually fairly straightforward to make, requiring only a few tools and supplies, using simple construction techniques. Screen doors can be either very simple in design, or can be more elaborate, depending upon your needs and construction abilities.
Supplies you’ll need, You will require some thin wood stock to use for the display door structure, a hardware framework for the doorway itself, and display meshing, together with a 1/4 inch by 3/4 inch screen molding. You will also require paint brushes, glue brushes, varnish and 1 inch nails. Some basic tools such as a tape measure, hamper, knife, chisel, staple gun and knobs will be needed.
Pick a well-dried timber to prevent future timber shrinkage, discoloration or warping. Measure the dimensions of the doorway you need to build, and cut on the horizontal and vertical pieces to fit. While building the doorway, it can help to clamp the door pieces to a work table. To make the corner joins, in addition to when adding the center horizontal support piece, you’ll need to take off half of the depth of a single piece of timber where they will match a saw, so that the general finished thickness of the joint will probably be equal to that of one piece of wood. Use a polyurethane glue and a brush to attach the timber service pieces together, and then clamp and allow to dry completely.
Adding the Screen to the Door, Putting the doorway flat on the work table, measure the general opening and cut a piece of display material into the proper size, leaving several inches around the edges to make installation simpler, which will be trimmed later. Lay the display over the top of the door frame, and staple it to the peak of the framework, pulling it tightly towards the base of the doorway. Make sure to pull on the display tightly in the horizontal directions too, keeping in mind that display will stretch over time. The display can be stapled directly to the doorway, as the staples will be covered by molding which will be placed around the edge of the display. After the display was stapled firmly into position, trim the display and cover the edges with the display molding.
Finishing the Job, Once the doorway itself was built, it is possible to install the door frame , and then attach the new screen door into the framework. Attach a door handle and fasten the door into the framework using spring hinges so that the door will close automatically.
