Lockable Screen Door

Prime Line Sliding Screen Door Latch Left Hand Chrome Diecast A with regard to measurements 1000 X 1000

Lockable Screen Door – A screen door is a superb way to not only allow some fresh air and sun into your house, but also to keep insects and other pests out at precisely the same moment. By using a screen door, you also have the capacity to maintain your house enclosed, while still allowing a breeze, either when the weather is hot or anytime you only need to allow just a little bit of fresh air in. Although you can purchase screen doors for your house, they are actually fairly straightforward to make, requiring only a few supplies and tools, using simple building techniques. Screen doors can be very simple in design, or can be elaborate, depending on your wants and building skills.

Supplies You Will Need, you’ll need some thin wood inventory to use for your screen door construction, a hardware framework for the doorway itself, and screen meshing, together with a 1/4 inch from 3/4 inch screen molding. You’ll also need paint brushes, glue brushes, varnish and 1 inch nails. Some basic tools such as a tape measure, hamper, knife, chisel, basic gun and clamps will be needed.

Designing and Cutting the Door, Thinner wood inventory is generally used when constructing a screen door, normally in a five-eighths thickness. Pick a well-dried timber to prevent future timber shrinkage, discoloration or warping. Measure the dimensions of the doorway you want to build, and cut on the horizontal and vertical pieces to fit. While constructing the doorway, it can help to clamp the door bits to a table. To make the corner combines, as well as when adding the centre horizontal reinforcement piece, you will want to take off half of the depth of a single piece of timber at the place where they will intersect with a saw, so that the overall finished thickness of the joint will probably be equivalent to that of one piece of wood. Use a polyurethane glue and a brush to attach the timber support bits together, and then clamp and allow to dry thoroughly. When the adhesive joints are completely dry, you can sand the doorway, and employ a stain and clear finish, or paint the door if needed.

Adding the Screen to the Door, Laying the doorway flat on the job table, measure the overall opening and cut a piece of screen material into the proper size, leaving several inches around the edges to make installation simpler, which will be trimmed later. Lay the screen over the surface of the door frame, and staple it to the peak of the framework, pulling it tightly towards the base of the doorway. Be sure that you pull on the screen tightly from the horizontal directions as well, keeping in mind that screen will elongate over time. The screen can be soldered right to the doorway, as the principles will be dealt with by molding which will be set around the edge of the screen. After the screen was stapled firmly into place, trim the screen and cover the edges with all the screen molding.

Finishing the Job, Once the doorway itself was assembled, it is possible to install the door frame , and also attach the new screen door into the framework. Attach a door handle and secure the door into the framework using spring hinges so that the door will shut mechanically.