Andersen Frenchwood Screen Door

Hinged Insect Screen Installation For Andersen 400 Series intended for proportions 1280 X 720

Andersen Frenchwood Screen Door – A screen door is a superb way to not only let some fresh air and sun to your house, but also to keep insects and other pests out in precisely the same time. By employing a screen door, you have the ability to keep your house enclosed, while allowing a breeze, either when the weather is hot or anytime you just want to let just a bit of fresh air in. Even though you can purchase screen doors for your house, they are actually fairly straightforward to make, requiring only a few tools and supplies, using simple construction methods. Screen doors can be either very simple in design, or could be more elaborate, based upon your wants and construction skills.

Supplies You Will Need, You will require some thin wood stock to use for the screen door construction, a hardware framework for the doorway itself, and screen meshing, together with a 1/4 inch from 3/4 inch screen molding. Some basic tools like a tape measure, hamper, knife, chisel, basic gun and knobs will be necessary.

Designing and Cutting the Door, Thinner wood stock is generally used when constructing a screen door, generally at a five-eighths thickness. Pick a well-dried wood to avoid future wood shrinkage, warping or swelling. Measure the dimensions of the doorway you need to build, and cut on the horizontal and vertical pieces to fit. While building the doorway, it can help to clamp the door bits to a table. To make the corner joins, in addition to when adding the center horizontal reinforcement piece, you’ll need to take off half of the thickness of a single piece of wood where they will intersect with a saw, so the general finished thickness of this joint will probably be equal to that of a single piece of wood. Utilize a polyurethane glue and a brush to attach the wood service bits together, then clamp and allow to dry thoroughly. When the adhesive joints are completely dry, you can sand the doorway, and employ a stain and clear finish, or paint the door if desired.

Adding the Screen to the Door, Laying the doorway flat on the job table, measure the general opening and cut a piece of screen material to the appropriate dimensions, leaving a few inches around the edges to make setup simpler, which will be trimmed later. Lay the screen over the top of the door frame, and staple it to the peak of the framework, pulling it tightly towards the base of the doorway. Be certain to pull on the screen tightly in the flat directions as well, keeping in mind that screen tends to elongate over time. The screen can be stapled directly to the doorway, as the principles will be dealt with by molding which will be set around the border of this screen. After the screen has been stapled firmly into position, trim the screen and cover the edges with all the screen molding.

Finishing the Job, Once the doorway itself has been assembled, it is possible to set up the door frame , and attach the new screen door to the framework. Attach a door handle and fasten the door to the framework with spring hinges so the door will close mechanically.