Fix Sliding Screen Door

Screen Doors Window Screen Repair Mobile Screen Service Econo pertaining to size 1808 X 2320

Fix Sliding Screen Door – A screen door is a great way to not only allow some fresh air and sun to your house, but also to keep insects and other pests out in the exact same moment. By employing a screen door, you also have the ability to maintain your house enclosed, while allowing a breeze, either when the weather is hot or anytime you just want to allow a little bit of fresh air in. Although you can purchase screen doors for your house, they are actually fairly simple to make, requiring only a few tools and supplies, using simple building methods. Display doors can be either very simple in layout, or could be elaborate, based upon your wants and building abilities.

Supplies You Will Need, You will need some thin wood inventory to use for your screen door structure, a hardware framework for the doorway itself, and screen meshing, along with a 1/4 inch from 3/4 inch screen molding. You’ll also need paint brushes, glue brushes, varnish and 1 inch nails. Some basic tools like a tape measure, hamper, knife, chisel, basic gun and knobs will be needed.

Designing and Cutting the Door, Thinner wood inventory is usually used when building a screen door, normally in a five-eighths thickness. Choose a well-dried timber to avoid future timber shrinkage, discoloration or warping. Measure the dimensions of the doorway you need to build, and cut on the vertical and horizontal pieces to fit. While constructing the doorway, it can help clamp the door bits to a work table. To make the corner joins, as well as when adding the center horizontal support piece, you’ll need to take off half the thickness of a single piece of timber where they will intersect with a saw, so the general finished thickness of this joint will probably be equivalent to that of one piece of wood. Use a polyurethane glue and a brush to attach the timber service bits together, and then clamp and allow to dry thoroughly.

Adding the Display to the Door, Putting the doorway flat on the work table, measure the general opening and cut a piece of screen material into the proper dimensions, leaving a few inches around the edges to make setup easier, which is trimmed later. Lay the screen over the top of the door frame, and staple it to the top of the framework, pulling it tightly towards the bottom of the doorway. Be sure to pull on the screen tightly from the flat directions too, keeping in mind that screen will stretch over time. The screen can be stapled directly to the doorway, as the staples will be covered by molding that will be set around the border of this screen. After the screen was stapled securely into place, trim the screen and cover the edges with the screen molding.

Finishing the Job, Once the doorway itself was assembled, you can set up the door frame , and also attach the new screen door into the framework. Attach a door handle and secure the door into the framework with spring hinges so the door will shut automatically.