Screen Door For Sliding Door

Built A Sliding Screen Door The Garage Journal Board Home for measurements 1024 X 768

Screen Door For Sliding Door – A screen door is a great way to not only let some fresh air and sunshine to your home, but also to keep insects and other pests out at the same time. By employing a screen door, you also have the capacity to maintain your home enclosed, while still allowing a breeze, possibly when the weather is warm or anytime you just want to let just a bit of atmosphere in. Even though you can purchase display doors for your home, they are actually fairly straightforward to make, requiring only a few supplies and tools, using simple building methods. Screen doors can be very simple in layout, or can be elaborate, based on your wants and building abilities.

Supplies you’ll need, you’ll require some thin wood stock to use for the display door structure, a hardware frame for the door itself, and display meshing, along with a 1/4 inch from 3/4 inch screen molding. You will also require paint brushes, glue brushes, varnish and one inch nails. Some basic tools such as a tape measure, hamper, knife, chisel, basic gun and knobs will be necessary.

Designing and Cutting the Door, Thinner wood stock is usually used when constructing a screen door, generally in a five-eighths thickness. Pick a well-dried timber to prevent future timber shrinkage, discoloration or warping. Measure the dimensions of the door you need to build, and cut the vertical and horizontal pieces to fit. While constructing the door, it can help to clamp the door bits to a table. To produce the corner combines, in addition to when adding the centre horizontal reinforcement piece, you’ll need to take off half of the thickness of a single piece of timber at the place where they will match a saw, so the overall finished thickness of the joint will probably be equal to that of one piece of wood. Utilize a polyurethane glue and a brush to attach the timber support bits together, and then clamp and let it dry thoroughly. Once the glue joints are completely dry, you can sand the door, and apply a stain and clear finish, or paint the door if needed.

Adding the Screen to the Door, Putting the door flat on the work table, measure the overall opening and cut a piece of display material into the proper size, leaving a few inches around the edges to make setup easier, which is trimmed later. Lay the display over the surface of the door frame, and staple it to the top of the frame, pulling it closely towards the base of the door. Be certain that you pull the display tightly in the horizontal directions as well, keeping in mind that display will stretch over time. The display can be stapled directly to the door, as the principles will be covered by molding that will be placed around the edge of the display. After the display has been stapled securely into place, trim the display and cover the edges with all the display molding.

Finishing the Job, when the door itself has been assembled, it is possible to install the door frame , and attach the new screen door into the frame. Attach a door handle and secure the door into the frame using spring hinges so the door will close mechanically.